How engineering works.

Clear explanations with interactive examples. Diagrams simplify reality and do not control any real equipment.

Recognizing injector control signals

Compare voltage/current for MPI, peak-and-hold, GDI and piezo. Distinguish a command pulse from coil current and actual fuel delivery.

INTERACTIVE EXAMPLESIMULATION

Who communicates with whom?

The ECU or injector driver controls the injector. Injector and driver design determine signal shape. Select MPI solenoid, peak-and-hold, GDI solenoid or piezo. All values are fictional teaching examples, not settings.

Voltage and waveform

The selected MPI example has approximately battery voltage on its low-side terminal when off, a low voltage when on, rising current and an inductive turn-off spike. Peak-and-hold uses higher opening current followed by lower holding current. GDI may use boosted opening voltage and a pulsed hold phase. A piezo element charges/discharges: opposite current pulses may surround a nearly current-free hold phase.

Measuring with an oscilloscope

For MPI/peak-and-hold the demo plots switched low-side voltage relative to the proper reference. For GDI/piezo it plots voltage across the element, a different measurement. Use wiring data, a suitable current clamp and rated voltage/differential probes. Never indiscriminately ground a floating driver with a scope clip.

The principle

Compare voltage and current together. An electrical pulse does not prove needle movement or adequate fuel flow. A current kink may indicate motion in some solenoids, but is not always visible. Multiple injection can include pilot, main and post events; the demo optionally shows a short pilot plus a longer main event.

An example

Select MPI with a 3 ms pulse: the switched terminal goes low and current rises. Then select piezo: observe charging and reverse discharge current pulses. Pulse without current illustrates that voltage alone does not establish energization or identify the exact location of an open circuit.

Important

GDI, diesel and piezo drivers may use hazardous voltages. Never electrically unplug a piezo injector with the engine running: remaining open can cause severe engine damage. Follow the actual manufacturer procedure. This simulator controls no hardware.

Technical source / documentation ↗