How engineering works.

Clear explanations with interactive examples. Diagrams simplify reality and do not control any real equipment.

PLC signal tester

Test a simple start/stop latch with a sensor, safety chain and reset.

INTERACTIVE EXAMPLESIMULATION

The principle

This simplified state model energizes an output only after enable, a closed safety chain and a start edge. Stop or loss of the safety chain turns it off. A fault stays latched until its cause clears and reset is pressed.

An example

Enable the system, press Start and change the sensor. Observe what Stop or opening the safety chain does.

Important

This is an educational logic demo only. Emergency stopping needs an appropriate safety architecture and must never rely on browser logic.

Technical source / documentation ↗