How engineering works.

Clear explanations with interactive examples. Diagrams simplify reality and do not control any real equipment.

Combustion engine process parameters

Connect engine speed, airflow, mixture and the four-stroke cycle. Adjust the model inputs and inspect pressure and fuel-flow examples.

INTERACTIVE EXAMPLESIMULATION

Who communicates with whom?

The ECU uses crank/cam signals, airflow or MAP, intake/coolant temperatures and lambda feedback to coordinate injection, ignition and air management. Always interpret data in context: cold start, warm idle and high load are different conditions.

Voltage and waveform

RPM measures crankshaft revolutions per minute. A four-stroke cycle takes two revolutions, or 720°. MAP is absolute manifold pressure, not boost pressure. MAF is air mass flow. Lambda is actual air/fuel mass ratio divided by its stoichiometric value: below one is rich, above one lean. The 14.7:1 value here is a gasoline example; fuel composition changes the reference.

Measuring with an oscilloscope

The pressure/crank-angle graph is an ideal teaching model of intake, compression, power and exhaust. It is not measured from OBD data. Actual cylinder-pressure measurement requires a suitable pressure sensor and synchronization. The displayed peak or compression ratio is not a compression test or diagnosis.

The principle

The airflow calculation uses ideal-gas density at the supplied MAP and intake temperature, with a fictional 85% volumetric factor. Fuel mass flow is air mass flow / (14.7 × λ). The pressure curve uses γ = 1.35 and a fixed fictional combustion pressure increase. Lambda changes only mixture calculations, not the pressure curve: these are separate teaching models. Actual valve timing, residual gas, combustion duration, friction and turbo dynamics are omitted.

An example

At 2,000 rpm one four-stroke cycle takes 60 ms. A model airflow of 14.7 g/s at λ = 1 implies 1.0 g/s of fuel. Compare idle and higher-load presets. A diesel uses compression ignition and usually excess air; the plotted Otto cycle is not a universal diesel model.

Important

Fuel pressure, injection time, ignition angle and fuel trims must be considered with operating conditions and manufacturer data. An unusual parameter alone does not prove its associated sensor faulty. No real-engine calibration settings are provided.

Technical source / documentation ↗