How engineering works.

Clear explanations with interactive examples. Diagrams simplify reality and do not control any real equipment.

Explaining ignition with an oscilloscope

Follow coil charging, firing, spark duration and ringing. Compare primary current/voltage, secondary voltage and a logic trigger.

INTERACTIVE EXAMPLESIMULATION

Who communicates with whom?

Ignition here means gasoline coil/spark-plug ignition, not diesel autoignition. A smart COP coil may contain its power switch, so its ECU trigger is not the primary high-voltage pulse.

Voltage and waveform

Primary current rises during dwell. Interrupting it rapidly changes the magnetic field and induces voltage. The secondary trace shows a firing peak, lower spark/burn voltage, then ringing. Polarity and scale depend on coil, measurement point and probe.

Measuring with an oscilloscope

Select primary switching voltage in V, coil current in A, secondary voltage in kV or a 0–5 V logic trigger. These are separate ideal examples. Use a suitable secondary pickup/high-voltage probe for secondary ignition, never a normal scope input directly on an HT lead. Primary inductive pulses also require appropriately rated accessories.

The principle

The example separates dwell, switch-off, spark line and damped ringing. Adjust dwell and example spark duration to recognize each time segment. No command produces neither charging current nor a firing spike in this model. Higher firing demand is only a different pattern, not proof of a cause.

An example

With 2.5 ms dwell and 1.5 ms spark duration, model firing occurs at 3.0 ms. Higher firing voltage can relate to plug gap, pressure, mixture or resistance. Compare cylinders under the same conditions and verify supply/current before condemning a coil.

Important

A single peak or ringing count is not conclusive diagnosis. The 5 V logic signal and polarity are examples, not universal pin assignments. Consult wiring diagrams and manufacturer probe/safety instructions.

Technical source / documentation ↗